COMBINED GENERAL WELLHEADS
27June 2016
COMBINED GENERAL WELLHEADS
- By: admin admin
- Category: Equipment
As the offshore oil and gas industry has continued to explore in progressively deeper waters, the requirements for well components have changed, as a result of the challenges associated with deep water drilling. Ocean-floor conditions in deep and ultra deep water can be extremely mushy and unconsolidated, which creates well-foundation problems that require development of new well designs to overcome the conditions. Second, underground aquifers in deep water have been observed in far greater frequency than in shallower waters, and it quickly became clear that these zones would have to be isolated with a casing string. Cementing requirements changed, and wellhead equipment designs would also have to change to accommodate the additional requirements.
With CG wellhead systems, conductor and intermediate casing strings can be reconfigured to strengthen and stiffen the upper section of the well (for higher bending capacities), and overcome the challenges of an unconsolidated ocean floor at the well site. Each "water flow” zone encountered while drilling requires isolation with casing and, at the same time, consumes a casing-hanger position in the wellhead. It became obvious that more casing strings and hangers were required to reach the targeted depth than the existing wellhead-system designs would accommodate.
HIGH-PRESSURE WELLHEAD RUNNING TOOL
CASING-HANGER SEAL-ASSEMBLY RUNNING TOOL
MULTIPURPOSE TOOL AND ACCESSORIES
Attention of an oil and gas operator that realizes there's a solution to their flare gas, by Combined General Company